NETGEAR PR2000

Hardware Setup
12
Trek N300 Travel Router and Range Extender PR2000
Connection Ports and Reset Button
Connect or reset your Trek.
WiFi
USB
USB
LAN
Internet/LAN
Reset
NE
TGEAR
Internet
Reset
button
Connection
ports
Figure 4. Connection ports and Reset button
Connect or reset your Trek using the following items:
• Reset button.
To reset the Trek to its factory settings, insert a paper clip into the Reset
hole and hold it until the Internet LED blinks. See Factory Settings on page 143 for
information about restoring factory settings.
• Internet/LAN port. When the Internet via switch is set to W
ired, this port becomes an
Internet port. When the switch is set to Wireless, this port becomes a LAN port for any
Ethernet-enabled device.
• LAN port.
A LAN port for any Ethernet-enabled device.
• USB port.
A USB port for USB storage or a USB printer. When the Trek is plugged into
the wall, the USB port can also be used as a cell phone charger.
WiFi LED
• Green. Either the LAN port or a wireless device is connected to the Trek.
• Off. No device is connected.
USB LED
• Green. The USB drive is properly mounted.
• Off. No USB drive is detected.
Table 1. Status LEDs (continued)