Supplemental Information
143
Trek N300 Travel Router and Range Extender PR2000
Factory Settings
You can return the Trek to its factory settings. Use the end of a paper clip or a similar object
to press and hold the Reset button for at least seven seconds. The Trek resets, and returns
to the factory configuration settings shown in the following table.
Table 4. Factory default settings
Feature Default Behavior
Router login User login URL www.routerlogin.com or www.routerlogin.net
User name (case-sensitive) admin (printed on product label)
Login password (case-sensitive) password (printed on product label)
Internet
connection
WAN MAC address Use default hardware address
WAN MTU size 1500
Port speed 10/100 Mbps Autosensing
Local network
(LAN)
LAN IP 192.168.168.1 (printed on product label)
Subnet mask 255.255.255.0
DHCP server Enabled
DHCP range 192.168.168.2 to 192.168.168.200
Allow a registrar to configure this
router
Enabled
DHCP starting IP address 192.168.168.2
DHCP ending IP address 192.168.168.200
DMZ Disabled
Time zone GMT-8 for NA
GMT+1 for GR, PE, UK
GMT+4 for RU
GMT+7 for PR
GMT+10 for AU
Time zone adjusted for daylight
saving time
Disabled
SNMP Disabled
Firewall Inbound (communications coming
in from the Internet)
Disabled (except traffic on port 80, the HTTP port)
Outbound (communications going
out to the Internet)
Enabled (all)
Source MAC filtering Disabled
To Next Page
Loading...
Need help?
General
