Advanced Settings
122
Trek N300 Travel Router and Range Extender PR2000
6. Click the Add button.
7. In the Route Name field, type a name for this static route (for identification purposes only).
8. If you want to limit access to the LAN only
, select the Private check box.
If you select Private, the static route is not reported in RIP.
9. T
o make this route effective, select the Active check box.
By default, the Active check box is selected.
10. T
ype the IP address of the final destination.
11. T
ype the IP subnet mask for this destination. If the destination is a single host, type
255.255.255.255.
12. T
ype the gateway IP address, which must be a Trek on the same LAN segment as the Trek.
13. T
ype a number from 1 through 15 as the metric value.
This value represents the number of Treks between your network and the destination.
Usually
, a setting of 2 or 3 works, but if this link is a direct connection, set it to 1.
14. Click the Apply button.
The route is added to the table on the Static Routes screen.
To edit or delete a static route:
1. Launch your browser from a computer or wireless device that is connected to the T
rek.
2. Enter www
.routerlogin.net or www.routerlogin.com in the web browser address bar.
The login screen displays.
3. Enter the T
rek user name and password.
The user name is admin.
The default password is password. The user name and
password are case-sensitive.
4. Click the OK button.
The BASIC Home screen displays.
To Next Page
Loading...
Need help?
General
