Features
The following list identifies the key features of the NETGEAR ProSafe FS726T Smart Switch.
• Twenty-four 10/100 Mbps and two 10/100/1000 Mbps auto-sensing Ethernet switching ports
• One SFP GBIC combo Gigabit Ethernet slot for optional fiber connectivity
• Automatic detection of SFP GBIC modules
• Reset Button.
• Factory Defaults Button.
• Administrative switch management including:
IEEE 802.1Q Tag VLAN with up to 64 VIDs ranging in 2 to 4K ♦
♦
♦
♦
♦
♦
♦
♦
♦
♦
♦
♦
♦
♦
♦
♦
♦
♦
♦
Port-based VLAN with up to 26 groups, any one port can belong to different VLAN groups
IEEE 802.1p QoS support, 4 priority queues per port
IEEE 802.3ad Link Aggregation support
Web-based management with embedded HTTP server provided
Supports port-setting function which allows user to enable/disable each port, set speed, duplex mode and device follow control
Support Auto-Discovery application program for discovering and managing the switches on the network
Support flash upgrading, configuration backup/restore and factory reset
• Full compatibility with IEEE standards:
IEEE 802.3i (10BASE-T)
IEEE 802.3u (100BASE-TX)
IEEE 802.3z/ab (1000BASE-X, 1000Base-T)
IEEE 802.3x (full-duplex flow control)
• Auto-sensing and auto-negotiating capabilities for all ports
• Auto Uplink™ on all ports to make the right connection
• Integrated address Look-Up Engine, supports 8K absolute MAC addresses
• Full- and half-duplex functions for all RJ-45 ports
• Store-and-Forward transmission to remove bad packets from the network
• Active flow control to minimize packet loss/frame drops:
Half-duplex back-pressure control
Full-duplex IEEE 802.3x pause frame flow control
• LED indicators for port status monitoring:
Power LED to indicate power on/off status
Link/Act LED to indicate link status and activity
Dual-color Mode LED to indicate speed, activity for Gigabit ports
• Flexible installation:
Standalone desktop installation
19-inch standard rack-mount
• Standard 1U case size
Page 6 of 19
To Next Page
Loading...
Need help?
General