Name: NETGEAR ProSafe GS748T
Brand: NETGEAR
Rating: 4 (1 reviews)

Other manuals for NETGEAR ProSafe GS748T

Operating Instructions20 pages

Specifications2 pages

Installation Guide2 pages

Questions and Answers:

B
Brian SmithJul 30, 2025
Why is the ACT LED flashing continuously on all connected ports on my NETGEAR ProSafe GS748T, and the network is disabled?
- V
  Vincent ColeJul 30, 2025
  A continuously flashing ACT LED on all connected ports, with the network disabled, indicates a network loop (redundant path) has been created. To resolve this, ensure there is only one path from any networked device to any other. You can break the loop manually. Alternatively, after connecting to the switch management interface, configure the Spanning Tree Protocol (STP) to prevent network loops.
E
elizabeth10Aug 3, 2025
What to do if a device is not recognized on NETGEAR ProSafe GS748T network?
- K
  Kristina HarrisAug 3, 2025
  If a segment or device is not recognized as part of the network when using your NETGEAR Switch, verify that the cabling is correct and that all connectors are securely positioned in the required ports. It's possible that equipment may have been accidentally disconnected, or that the cabling does not meet Ethernet guidelines.
E
evanskimAug 7, 2025
How to fix NETGEAR ProSafe GS748T Switch when link LED is off?
- R
  Richard PetersAug 7, 2025
  If the Link LED on your NETGEAR Switch is off or intermittent, it indicates a port connection issue. Check the crimp on the connectors, and ensure the plug is properly inserted and locked into the port at both the switch and the connecting device. Also, ensure all cables used are correct and comply with Ethernet specifications. If problems persist, test for a defective computer adapter card, cable, or port in an alternate environment where all products are functioning.
T
Theresa JensenAug 11, 2025
How to troubleshoot NETGEAR Switch when power LED is off?
- T
  teresaholderAug 12, 2025
  If the Power LED on your NETGEAR Switch is off, it means no power is being received. Check the power cord connections and the connected device. Ensure all cables used are correct and comply with Ethernet specifications.