Need help?Do you have a question about the NETGEAR ProSAFE JGS524Ev2 and is the answer not in the manual?
General| Model | JGS524Ev2 |
|---|---|
| Category | Switch |
| Switching Capacity | 48 Gbps |
| Forwarding Rate | 35.7 Mpps |
| MAC Address Table Size | 8K |
| Energy Efficient Ethernet (EEE) | Yes |
| Fanless Design | Yes |
| Switch Type | Unmanaged |
| VLAN Support | Yes |
| Quality of Service (QoS) | Yes |
| Management | Web-based management GUI |
| Mounting Options | Rackmountable |
| Power Supply | Internal |
| Operating Temperature | 0°C to 40°C |
| Storage Temperature | -20°C to 70°C (-4° to 158°F) |
| Humidity | 90% (non-condensing) |
| Ports | 24 x 10/100/1000BASE-T RJ45 |
Overview of initial switch setup and connection procedures.
Instructions for accessing the switch's interface via a web browser, including off-network and on-network methods.
Guide to using the dedicated software utility for switch management, including installation.
Instructions for changing the default switch password for security, via browser or utility.
Configure the switch's IP address, subnet mask, and gateway using browser or utility methods.
Optimize multicast traffic forwarding using IGMP snooping via browser or utility methods.
Create LAGs for bandwidth and redundancy using browser or utility methods.
Implement QoS based on packet header priority tags using browser or utility methods.
Assign priority levels to traffic on a per-port basis using browser or utility methods.
Control ingress and egress traffic rates on switch ports using browser or utility methods.
Update the switch's firmware to the latest version using browser or utility methods.
Reset the switch to its original factory default configuration using browser or utility methods.
To Next Page