To set up the router as an AP:
1.
Use an Ethernet cable to connect the Internet port of this router to an Ethernet port
in the other router.
2.
Launch a web browser from a computer or mobile device that is connected to the
network.
3.
Enter http://www.routerlogin.net.
A login window opens.
4. Enter the router user name and password.
The user name is admin. The default password is password. The user name and
password are case-sensitive.
The BASIC Home page displays.
5.
Select ADVANCED > Advanced Setup > Router/ AP / Bridge Mode.
The Router / AP / Bridge Mode page displays.
6.
Select AP Mode.
The page adjusts.
7. Select an IP address setting:
• Get dynamically from existing router. The other router on the network assigns
an IP address to this router while it is in AP mode.
• Use fixed IP settings on this device (not recommended). Use this setting if you
want to manually assign a specific IP address to this router while it is in AP mode.
Using this option effectively requires advanced network experience.
Note: To avoid interference with other routers or gateways in your network, we
recommend that you use different WiFi settings on each router. You can also turn
off the WiFi radio on the other router or gateway and use this router only for WiFi
client access.
8.
Click the Apply button.
The IP address of the router changes, and you are disconnected.
9.
To reconnect, close and restart your browser and type http://www.routerlogin.net.
User Manual81Manage Network Settings
Nighthawk X6S AC3600 Tri-Band WiFi Router Model R7960P
To Next Page
Loading...
Need help?
General
