NETGEAR R8000P User Manual

LEDs and Buttons on the Top Panel
The status LEDs are located on the top of the router.
Table 1. LED descriptions
DescriptionLED
• Solid white.The router is ready.
• Blinking white.The router is not ready, firmware is upgrading, or the Reset button was
pressed.
• Off. Power is not supplied to the router.
Power
• Solid white. An Ethernet connection is established.
• Blinking white.The port is sending or receiving traffic.
• Off. No Ethernet cable is connected between the router and the modem.
Internet
• Solid white.The 2.4 GHz WiFi radio is operating.
• Blinking.The router is sending or receiving WiFi traffic.
• Off.The 2.4 GHz WiFi radio is off.
2.4 GHz WiFi
• Solid white.The 5 GHz 1 WiFi radio is operating.
• Blinking.The router is sending or receiving WiFi traffic.
• Off.The 5 GHz 1 WiFi radio is off.
5 GHz 1 WiFi
• Solid white.The 5 GHz 2 WiFi radio is operating.
• Blinking.The router is sending or receiving WiFi traffic.
• Off.The 5 GHz 2 WiFi radio is off.
5 GHz 2 WiFi
The USB 3.0 LED is for the USB 3.0 USB port.The USB 2.0 LED is for the USB 2.0 port.
• Solid white. A USB device is connected and is ready.
• Blinking. A USB device is plugged in and is trying to connect.
• Off. No USB device is connected, or someone clicked the Safely Remove Hardware button
and it is now safe to remove the attached USB device.
USB 3.0 port
USB 2.0 port
Hardware Setup
10
Nighthawk X6S AC4000 Tri-Band WiFi Router

NETGEAR R8000P Specifications

General

Brand	NETGEAR
Model	R8000P
Category	Wireless Router
Language	English