NETGEAR R8000P User Manual

Factory Settings
You can return the router to its factory settings. Use the end of a paper clip or a similar object to press and
hold the Reset button on the back of the router for at least seven seconds.The router resets and returns
to the factory configuration settings shown in the following table.
Table 3. Factory default settings
Default settingFeature
www.routerlogin.com or www.routerlogin.netUser login URLRouter login
adminUser name (case-sensitive)
passwordLogin password (case-sensitive)
Use default hardware addressWAN MAC addressInternet
connection
1500WAN MTU size
AutoSensingPort speed
192.168.1.1LAN IPLocal network
(LAN)
255.255.255.0Subnet mask
EnabledDHCP server
192.168.1.2 to 192.168.1.254DHCP range
Pacific timeTime zone
192.168.1.2DHCP starting IP address
192.168.1.254DHCP ending IP address
DisabledDMZ
DisabledTime adjusted for daylight saving
time
DisabledSNMP
Disabled (except traffic on port 80, the HTTP port)Inbound (communications coming
in from the Internet)
Firewall
Enabled (all)Outbound (communications going
out to the Internet)
DisabledSource MAC filtering
Supplemental Information
140
Nighthawk X6S AC4000 Tri-Band WiFi Router

NETGEAR R8000P Specifications

General

Brand	NETGEAR
Model	R8000P
Category	Wireless Router
Language	English