NETGEAR R8300 User Manual

4. Select ADVANCED > Setup > LAN Setup.
Your router might display information that is different from this example.
5. In the IP Address field, type the IP address.
6. In the IP Subnet Mask, type the subnet mask of the router.
The IP address and subnet mask identify which addresses are local to a specific device and which must be
reached through a gateway or router.
7. Change the RIP settings.
Router Information Protocol (RIP) allows a router to exchange routing information with other routers.
a. Select the RIP direction:
• Both.The router broadcasts its routing table periodically and incorporates information that it receives.
• Out Only.The router broadcasts its routing table periodically.
• In Only.The router incorporates the RIP information that it receives.
b. Select the RIP version:
• Disabled.This is the default setting.
• RIP-1.This format is universally supported. It is adequate for most networks, unless you are using an
unusual network setup.
• RIP-2.This format carries more information. Both RIP-2B and RIP-2M send the routing data in RIP-2
format. RIP-2B uses subnet broadcasting. RIP-2M uses multicasting.
8. Click the Apply button.
Your settings are saved.
Network Settings
72
Nighthawk X8 AC5000 Tri-Band WiFi Router

NETGEAR R8300 Specifications

General

Brand	NETGEAR
Model	R8300
Category	Network Router
Language	English