NETGEAR RAX43 User Manual

Rear panel
The following figure shows the rear panel connectors and buttons.
1 2 4 5 63
Figure 3. Rear panel
The rear panel contains the following components:
1. Reset button. Pressing the Reset button resets the router.
If the Reset button is pressed for at least 10 seconds and the Power LED blinks, the
router returns to its factory settings.
2. USB 3.0 port. Use the USB 3.0 port to connect USB storage device.
3. Ethernet ports. Four Gigabit Ethernet RJ-45 LAN ports. Use these ports to connect
LAN devices to the router.
4. Internet port. One Gigabit Ethernet RJ-45 WAN port to connect the router to an
Internet modem such as a cable modem or DSL modem.
5. DC power connector. Connect the power adapter that came in the product package
to the DC power connector.
6. Power On/Off button. Press the Power On/Off button to provide power to the
router.
User Manual12Hardware Setup
Nighthawk AX5 5-Stream WiFi Router

NETGEAR RAX43 Specifications

General

USB Ports	1 x USB 3.0
Antenna	4 external antennas
Beamforming	Yes
MU-MIMO	Yes
OFDMA	Yes
WiFi Technology	WiFi 6 (802.11ax)
Ethernet Ports	5 x 1G Ethernet ports
Security	WPA3
Memory	512MB RAM
Bands	Tri-band (2.4 GHz, 5 GHz, 5 GHz)