NETGEAR RNDU4000-100NAS

Monitor, Maintain, and Optimize
119
ReadyNAS for Home RAIDiator 4.2
 To enable the power timer:
1. Select System > Power from the FrontView main menu.
The Power screen displays.
Scroll down to the Power Timer pane.
2. Select the Enable power timer check box.
The drop-down lists become active.
3. Use the drop-down lists to configure when your ReadyNAS system powers itself off and
powers itself back on.
4. Click the Apply button.
Your settings are saved.
Connect to a UPS
Connecting your ReadyNAS storage system to an uninterruptible power supply (UPS) device
is an easy way to protect against data loss due to power failures.
If you set up email notifications, your ReadyNAS system sends you an email alert message
whenever the UPS status changes. For example, if a power failure forces the UPS into
battery mode, or when the battery is low, you receive an email message. When the battery is
low, your ReadyNAS system automatically shuts down safely.
 To connect your ReadyNAS system to a UPS:
1. Connect the ReadyNAS power cable to the UPS.
2. Connect the UPS USB monitoring cable to a USB port on your ReadyNAS system.
FrontView detects compatible UPS units automatically and displays information about the
UPS on the status bar.
For a list of compatible UPS units, see the hardware compatibility list at
http://www.readynas.com/?page_id=92
.