Disk Configuration
29
ReadyNAS for Home RAIDiator 4.2
Change from X-RAID2 to Flex-RAID
You can reconfigure your system from X-RAID2 mode (the factory default mode) to
Flex-RAID mode.
To change from X-RAID2 to Flex-RAID:
1. If any data is stored on your system, back up your data.
For more information, see the Back Up Data Stored On Your ReadyNAS System on
page 130.
2. Perform a factory reset reboot.
WARNING!
Setting your ReadyNAS system to its factory defaults erases all
data and configuration settings.
The process for performing a factory reset reboot varies by storage system. For more
information about how to perform a factory reset reboot, see the ReadyNAS Ultra, Ultra
Plus, NVX, and Pro Series Hardware Manual.
During the factory reboot process, you have a 10-minute window to choose a RAID
configuration. RAIDar sends a prompt to click the Setup button during this 10-minute time
frame.
3. Launch RAIDar, highlight your storage system, and click the Setup button.
The ReadyNAS Volume Setup screen displays.
To Next Page
Loading...
