Getting Started
14
ReadyNAS for Home RAIDiator 4.2
Setup Wizard
When you launch FrontView for the first time, FrontView launches in Wizard mode. FrontView
also launches in Wizard mode the first time you use your storage system after a factory
default reboot.
NETGEAR recommends using the Setup Wizard the first time you use your storage system.
The Setup Wizard guides you step-by-step through the configuration process, assisting you
in quickly integrating your ReadyNAS storage system into your network. Follow the Setup
Wizard’s prompts to configure the following settings:
• Disk configuration. The Setup Wizard configures your system in X-RAID2 mode. For
more information, see
X-RAID2 on page 18. If you want to configure your system in
Flex-RAID mode, you can change the configuration after you complete the Setup Wizard.
For more information, see
Change from X-RAID2 to Flex-RAID on page 29.
• Time and date. For more information, see Clock on page 79.
• Contact email addresses. For more information, see Email Alert Contacts on page 80.
• IP addresses. For more information, see Ethernet on page 88.
• Hostname. For more information, see Hostname on page 91.
• DNS settings. For more information, see DNS on page 92.
• Administrator password and password recovery question and answer. For more
information, see
Administrator Password on page 84.
• User and group accounts. For more information, see Basic User and Group Concepts
on page 61.
• File-sharing protocols. For more information, see File-Sharing Protocols on page 33.
• Streaming services. For more information, see Streaming Services on page 95.
• Shares. For more information, see Basic Share Concepts on page 32.
• Printers. For more information, see Printer Queue Service on page 87.
• Product registration. For more information, see Register Your System on page 9.
To switch to Advanced Control mode, click the Switch to Advanced Control button.
To Next Page
Loading...
