NETGEAR Tri-band Mesh WiFi 6 Router User Manual

To change the NTP server to your preferred NTP server:
1.
Launch a web browser from a computer or mobile device that is connected to your
mesh network.
2.
Enter http://www.routerlogin.net.
A login window opens.
3. Enter the router admin user name and password.
The user name is admin. The password is the one that you specified the first time
that you logged in. The user name and password are case-sensitive.
The BASIC Home page displays.
4. Select ADVANCED > Administration > NTP Settings.
The NTP Settings page displays.
5.
Select the Set your preferred NTP server radio button.
6.
Enter the NTP server domain name or IP address in the Primary NTP server field.
7. Click the Apply button.
Your settings are saved.
Set up the router as a WiFi access point
You can set up the router to run as an access point (AP) on the same local network as
another router.
To set up the router as an AP:
1.
Use an Ethernet cable to connect the Internet port of this router to an Ethernet port
on the other router.
2.
Launch a web browser from a computer or mobile device that is connected to your
mesh network.
3.
Enter http://www.routerlogin.net.
A login window opens.
4. Enter the router admin user name and password.
The user name is admin. The password is the one that you specified the first time
that you logged in. The user name and password are case-sensitive.
The BASIC Home page displays.
5. Select ADVANCED > Advanced Setup > Wireless AP.
The Wireless AP page displays.
User Manual83Manage Network Settings
Nighthawk Tri-band Mesh WiFi 6

NETGEAR Tri-band Mesh WiFi 6 Router Specifications

General

Brand	NETGEAR
Model	Tri-band Mesh WiFi 6 Router
Category	Network Router
Language	English