To configure an IPTV port:
1.
Launch a web browser from a computer or mobile device that is connected to your
mesh network.
2.
Enter http://www.routerlogin.net.
A login window opens.
3. Enter the router user name and password.
The user name is admin. The password is the one that you specified the first time
that you logged in. The user name and password are case-sensitive.
The BASIC Home page displays.
4.
Select ADVANCED > Advanced Setup > VLAN/Bridge Settings.
The VLAN/Bridge Settings page displays.
5.
Select the Enable VLAN/Bridge Setup check box.
The page expands.
6. Select the By bridge group radio button.
The page expands.
7. Select the Port1 check box:
8. Click the Apply button.
Your settings are saved.
Manage custom static routes
For almost all Internet traffic, routes are automatically and dynamically selected. You
can also set up a fixed, static route. Typically, you only need to add static routes when
you have more than one router or multiple IP subnets on your network.
As an example of when a static route is needed, consider the following case:
•
Your main Internet access is through a cable modem to your ISP. The cable modem
is connected to your router.
•
Your network also includes an ADSL router that you use to access a remote office
site. This ADSL router is connected to a DSL modem, which is used on-demand only.
•
Your LAN subnet is 192.168.1.0, and the ADSL router’s address on your LAN is
192.168.1.100.
•
The public IP address range at the remote office site is 134.177.0.0.
User Manual87Manage Network Settings
Nighthawk Tri-band Mesh WiFi 6
To Next Page
Loading...
Need help?
General
