NETGEAR RangeMax NEXT Wireless PCI Adapter WN311B User Manual
2-12 Network Connections and Wireless Security
v1.0, October 2008
b. Select or enter the Network Name (SSID) for the Ad Hoc network.
c. In the Profiles box, type the name of the profile.
d. Click Apply.
3. Save your settings in a Profile.
a. Click the Save Profile button.
All the configuration settings are saved in this profile.
b. Click Apply.
c. Click Close to exit the Smart Wizard, or Cancel to return to the previous settings.
4. Configure the PC network settings.
a. Configure each PC with either a static IP address or with the IPX protocol.
b. Restart the PCs.
1. Verify wireless connectivity between your peer devices with the Ping program:
a. On the Windows taskbar click the Start button, and then click Run.
b. Assuming the target PC is configured with 192.168.0.1 as its IP address, type
ping -t
192.168.0.1
and then click OK.
Note: For instructions on configuring static IP addresses, refer to the networking
tutorial on your Resource CD.
Figure 2-10
To Next Page
Loading...
