NETGEAR WNA1100 - Wireless-N 150 USB Adapter User Manual (English)

Other manuals for NETGEAR WNA1100 - Wireless-N 150 USB Adapter

Questions and Answers:

B
Brett TaylorJul 26, 2025
What to do if I cannot connect to a wireless network with my NETGEAR Adapter, even with good signal strength?
- A
  Amber BuckleyJul 26, 2025
  First, check if you're still connected to a previous network and use the Networks tab to select the desired network. If the network uses Push 'N' Connect, ensure you select the correct network and press the WPS button on the correct router when prompted. If you're manually entering a passphrase, key, or SSID for a hidden network, ensure it matches the wireless network settings exactly.
J
James NicholsJul 30, 2025
What to do if I can connect to the wireless network, but not to the other computers on the network or to the Internet with my NETGEAR WNA1100 - Wireless-N 150 USB Adapter?
- V
  Valerie AcostaJul 30, 2025
  Ensure the router is physically connected to the Ethernet network. Also, verify that the IP addresses and Windows networking are configured correctly. If problems persist, restart the modem, router, and computer.
M
Mark BakerAug 3, 2025
What to do if my NETGEAR Adapter LED is not lit?
- S
  Susan AlexanderAug 3, 2025
  If the LED is not lit, try removing and reinserting the wireless-N USB adapter. Check the Windows device manager to see if the adapter is recognized and enabled. If necessary, reinstall the WNA1100 v1 software. You can also try inserting the wireless-N USB adapter into a different USB slot on your computer, if available.
B
Bradley SanchezAug 8, 2025
Why does the Smart Wizard keep asking me to save my settings on my NETGEAR WNA1100 - Wireless-N 150 USB Adapter?
- M
  mconradAug 8, 2025
  To prevent the Smart Wizard from prompting you to save settings repeatedly, click 'Apply' before closing the Smart Wizard.
T
Todd JimenezAug 12, 2025
What does it mean if my NETGEAR Adapter LED blinks, but the wireless-N USB adapter is not connected to a wireless network?
- S
  snyderphillipAug 12, 2025
  If the LED blinks but the adapter isn't connected, it means the wireless-N USB adapter is trying to connect unsuccessfully. The router might not be powered on, or the router and the wireless-N USB adapter might not be configured with the same wireless settings. Check the SSID and wireless security settings.
C
Charles SavageAug 16, 2025
What does 'Connection Status Shows ---.---.-.-' mean for NETGEAR WNA1100 - Wireless-N 150 USB?
- D
  Diana WilliamsAug 16, 2025
  This status can appear if you upgraded your WNA1100 v1 software and did not reboot your system. To resolve this, either restart your computer or connect to a different wireless network.

NETGEAR WNA1100 - Wireless-N 150 USB Adapter Specifications

General

Interface	USB 2.0
Frequency Band	2.4 GHz
Data Transfer Rate	Up to 150 Mbps
Antenna	Internal
Wireless Standard	IEEE 802.11b/g/n
Security	WEP, WPA-PSK, WPA2-PSK
Operating System Compatibility	Windows XP, Windows Vista, Windows 7