NETGEAR WNA1100 - Wireless-N 150 USB Adapter User Manual

Wireless-N 300 USB Adapter WNA3100 User Manual
1-5
v1.0, December 2009
4. Follow the prompts to complete the installation.
How you connect to a network depends on what you selected during custom installation.
• For automatic configuration, see the following section, “Use Smart Wizard Automatic
Configuration to Connect to a Wireless Network.”
• If you selected manual configuration, the Settings tab displays. See “Joining a Network”
on page 2-2.
• To use a Windows utility, see your Windows documentation or the NETGEAR application
note at http://documentation.netgear.com/reference/enu/winzerocfg/index.htm.
Use Smart Wizard Automatic Configuration to Connect to a
Wireless Network
After the driver is installed, you are prompted to connect to a wireless network.
1. One of the following screens displays:
• If no WPS networks are in your area, select your wireless network from the list and click
Next. If you select a secured network, you need to enter the passphrase or network key.
Figure 1-5
WPS-capable networks in your area No WPS-capable networks in your area

NETGEAR WNA1100 - Wireless-N 150 USB Adapter Specifications

General

Interface	USB 2.0
Frequency Band	2.4 GHz
Data Transfer Rate	Up to 150 Mbps
Antenna	Internal
Wireless Standard	IEEE 802.11b/g/n
Security	WEP, WPA-PSK, WPA2-PSK
Operating System Compatibility	Windows XP, Windows Vista, Windows 7