NETGEAR WNCE3001 User Manual

Getting Started
6
Universal Dual Band WiFi Internet Adapter (WNCE3001)
Power Connection Options
You can power on your Internet adapter using either of these methods:
• Connect the WNCE3001 to an electrical outlet with the included power adapter.
Figure 3. Power adapter
• Connect the WNCE3001 to any USB port with the included USB power cable:
Figure 4. USB power cable
Note: Make sure that the device where you connect the USB power cable
is powered on. Some USB ports on consumer electronic devices
cannot provide the power that the Internet adapter requires. In such
cases, the LED turns solid red, and the Internet adapter might reset
itself or turn itself off. Even if the Internet adapter is powered on
successfully, you might experience continuous disconnection during
file transfer. If this happens, try connecting the USB cable to a
different device, or use the Internet adapter power adapter instead.
Installation
The Universal Dual Band WiFi Internet Adapter (WNCE3001) Installation Guide, included in
the package, explains how to install your Internet adapter. The steps are summarized in this
section.

NETGEAR WNCE3001 Specifications

General

Interface	WLAN
Connectivity technology	Wireless
Ethernet LAN (RJ-45) ports	1
Chipset	-
Internal	No
Product color	Black
LED indicators	Yes
Wi-Fi band	Dual-band (2.4 GHz / 5 GHz)
Frequency range	2.4 - 5 GHz
Wi-Fi standards	802.11b, 802.11g, Wi-Fi 4 (802.11n)
Cabling technology	10/100BaseT(X)
Top Wi-Fi standard	Wi-Fi 4 (802.11n)
Security algorithms	WEP, WPA-PSK, WPA2-PSK
Networking standards	IEEE 802.11b, IEEE 802.11g, IEEE 802.11n
Maximum data transfer rate	100 Mbit/s
Supported data transfer rates	10/100 Mbit/s
Windows operating systems supported	Windows 8
Cables included	LAN (RJ-45), USB

Weight and Dimensions

Depth	29 mm
Width	73 mm
Height	102 mm
Weight	61.7 g