N300 Wireless Router with USB WNR2200 User Manual
Configuring Your Internet Connection 2-5
v1.0, May 2011
• If you are connected to the Internet and select a language that is not already stored in flash
memory, the language is downloaded from the NETGEAR server and stored in the current
language partition of flash memory.
• If you are not connected to the Internet when you select a language, you can only select as the
current language one of the languages that is stored in flash memory.
To specify a language to be used on your router manager screens, do the following:
1. Expand the list and select the language you want.
2. Click Apply.
The language you select is then downloaded and displayed in the language selection box, and
your screen display will be in the selected language.
Using the Setup Wizard
You can manually configure your Internet connection using the Basic Settings screen, or you can
allow the Smart Setup Wizard to detect your Internet connection. The Smart Setup Wizard
searches your Internet connection for servers and protocols to determine your ISP configuration.
This feature is not the same as the Smart Wizard that is used for installation. To use the Smart
Setup Wizard to assist with configuration or to verify the Internet connection settings, follow this
procedure:
1. From the top of the main menu, select Setup Wizard.
2. Select Yes for the Auto-Detect Connection Type, and then click Next to proceed.
3. Enter your ISP settings, as needed.
4. At the end of the Setup Wizard, click Test to verify your Internet connection. If you have
trouble connecting to the Internet, see Chapter 9, “Troubleshooting.”
Note: If you are not connected to the Internet and select a language that is not stored
in flash memory, your selection may fail. If you see a “download fails”
message after your language selection, make sure you are connected to the
Internet and make your selection again.
To Next Page
Loading...
