(4)
Working Mode
If you are heading for a working area which lies outside the Bluetooth signal
range, you may activate scanner’s store mode, following steps described below.
Under this mode, all scanned data will be stored directly into the buffer
memory of the device. Furthermore, data entries will be permanently saved in
the buffer memory prior to the manual upload into the working station, so that
you may upload them when you are near your working device.
$LAN#TK
Turkey Q keyboard
$LAN#TF
Turkey F keyboard
*Normal Mode Store Mode
Output Stored Data Output Total Entry
Clear Memory
Note: On Store Mode scanner will make 2 beeps when memory is full .
To Next Page
Loading...
