NT-W5
Quick Setup Guide
This is 1D&2D plug and play model if you use a US keyboard. If you use other type of keyboard, plug
the USB cable on your device , setup keyboard language before you use it. (refer to below Keyboard
Language Type) after that the scanner can start to work.
If you want to do other configurations please refer to below programming barcodes.
Barcode Programming
Netum barcode scanners are factory programmed for common terminal and communications
settings. If you need to change these settings, programming is accomplished by scanning the bar
codes in this guide. An asterisk (*) next to an option indicates the default setting.
Communication Mode
USB -KBW
When you connect the scanner to the Host via a USB connection, you can enable the USB-KBW
feature by scanning the barcode below. It works on a Plug and Play basis and no driver is
required.
USB KBW*
USB Serial Port
If you connect scanner to the Host via a USB connection, the USB COM Port Emulation feature
allows the Host to receive data in the way as a serial port does.
To Next Page
Need help?
General
