Netum NT-W8 User Manual

R
► USB wired + 2.4G wireless communication
► Built-in FLASH memory, supports breakpoint resume
► Can store 2600 pieces Code-128 codes under offline state
► Supports Windows XP, Win7/8, Wince, mobile OS PC
Quick Start Guide
Packing list:
Barcode scanner x 1 pc
USB cable x 1pc
2.4G receiver x 1pc
Quick Start Guide x 1pc
Note: The device is not equipped with the charger, please charge the
device via USB output charging equipment.

Netum NT-W8 Specifications

General

Type	Wireless Barcode Scanner
Connectivity	Wireless
Scanning Technology	Laser
Wireless Technology	Bluetooth
Operating Frequency	2.4GHz
Compatibility	Windows
Interface	USB
Supported Barcode Types	Code 128, Code 39, EAN-8, EAN-13, UPC-A
Operating Voltage	5V

Summary

2.4G Wireless Barcode Scanner Overview

Factory Default Configuration

Configure scanner to default settings using specific barcodes.

Scanning Mode

Key Holding

Trigger reading by pressing and holding the button.

Continuous Mode

Scanner performs continuous scanning until a condition is met.

Automatic Induction Mode

Scan based on ambient brightness changes.

Offline Mode Configurations

Activate Offline Mode

Enable offline scanning mode by scanning a barcode.

Clear Storage

Delete all data stored in the buffer memory in offline mode.

Manual Data Upload

Upload stored data entries manually after reconnection.

Summarise Uploaded Data Quantity

View the total count of uploaded data entries in offline mode.

Offline Mode Management

Quit Offline Mode

Exit offline mode and reinitialize the scanner to normal operation.

Terminator Configuration

Disable Terminator

Configure the scanner to not append any terminator characters.

CR & LF Terminator

Set Carriage Return and Line Feed as terminator.

Prefix/Suffix Values Setup

Scan Prefix

Configure a prefix to be appended to scanned data.

Scan Suffix 1

Configure the first suffix to be appended to scanned data.

Scan Suffix 2

Configure the second suffix to be appended to scanned data.

Scan Data Transmission Format

Setting Prefixes and Suffixes

Prefix Setting Procedure

Step-by-step guide to set a prefix for scanned data.

Suffix Setting Procedure

Step-by-step guide to set suffixes for scanned data.

Common Barcode Functions

Code 128 Enable/Disable

Control the scanning of Code 128 barcodes.

Code 39 Enable/Disable

Control the scanning of Code 39 barcodes.

Code 39 Full ASCII Enable/Disable

Control the scanning of Code 39 Full ASCII barcodes.

Setting Prefixes and Suffixes Via Serial Commands