2.4G Wireless Barcode Scanner Overview
Netum 2.4G wireless model integrates a high-performance processer with an effective decoding
board, combining a fast decoding speed. High precision and a high anti-interference ability in one
device. The device can easily read barcodes on paper and other surface.
2.4 GHz Wireless
USB2.0 Wired
Factory Default Configuration
This confirguration including four steps,Please scan below codes one by one .
· Step 1 : Factory default · Step 2 : Enable Code 39
303FFF3
1000111
· Step3 : Serial Port · Step 4 : Baud Rate 19200
3030010 2090107
Note that there will not have a beep sound after you scan code of “default configuration”.
As long as light turns off a few seconds before you release the trigger button that means scanner
has read the codes successfully. keep scanning the following codes until last one to finish the
default configuration.
1
To Next Page
Loading...
Need help?
General
