EasyManua.ls Logo

NETZSCH NM038BY - 3 PACKAGING, TRANSPORTATION, STORAGE; 3.1 Packaging and Transportation

Default Icon
109 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
3 PACKAGING, TRANSPORTATION,
STORAGE
PAGE
3.0
3 Packaging, Transportation, Storage
3.1 Packaging and Transportation
NEMO
®
pumps are shipped in railroad containers or crates unless the customer
specifies otherwise.
The packings are labelled and symbols give the handling instructions in accordance
with DIN 55402.
On receipt check for any transport damages.
Transport damages should be reported to the transporter immediately.
The pumps should be transported as closely as possible to the location of installation
and only there should they be uncrated.
Uncrated horizontal pumps should be lifted by using a shackle which can be attached
to the baseplate. The bolt holes of the frame or the lifting lugs attached to the
baseplate could be used as shown on the installation drawing.
Vertical pumps should be lifted by using the bolt down holes, lifting lugs or shackles
attached to the baseplate. This is shown on the installation drawing. For most
applications, the drive is mounted on top of the pump.
Be careful when lifting top heavy pumps. The centre of gravity may be above the
points where the lifting gear is attached to. If the case, secure additionally against
tipping over!
Vertical pumps should not be deposited unless they are secured vertically. Hazards of
tipping!
Deposit only in horizontal position.
It is essential to avoid that the total pump unit be suspended with eye bolts of the
motor or gear box. These eye bolts should be used for lifting the motor and/or the
gear box only.
The local accident prevention rules relating to lifting accessories for the
lifting of loads must be strictly adhered to.
Because of the variety of possible pump designs and applications, only general
instructions can be given here. These should be good enough for experienced
assemblymen or transportation experts.
When in doubt, please ask for detailed information on the pump unit concerned.
When moving the pump or unit on wheels strictly attend to the following:
I Pad lock the motor drive and secure against unintended starting up.
I Move the pump unit carefully and slowly, especially where the ground is uneven.
Hazards of tipping!
issued: 27.07.2013 Revision: 7
text no.
03000-1/2
copy to:
IPP - EN - EN_03000_20150727/1 - D8411276 - 4300003998 - 000100 - NPS - 00229929 N 2018-02-21 19:03:25
17

Related product manuals