1 SAFETY PRECAUTIONS
PAGE
1.1R
- Media and lubricants that escape during maintenance must be wiped off
immediately and disposed of in accordance with environmental regulations. Wear
slip-resistant shoes!
- All safety and protection equipment must be reattached or reactivated and tested
immediately after maintenance work has been completed.
- The actions listed in the step "Start-up" (→ Chapter 5) must be followed before
restarting.
- Because the required time intervals for cleaning and maintenance work depend
very heavily on the conveyor medium and the other operating conditions, it is not
possible in most cases to give fixed intervals.
The required intervals for cleaning and maintenance must be determined
and laid down by the operator in operation.
1.6 Unauthorised modifications, use of original parts
- Modification or changes to the machine are only permissible upon consultation and
with the written agreement of NETZSCH.
- For reasons of operating and equipment safety, the supplied machines may only be
operated with original spare parts and accessories and auxiliary materials
authorised by NETZSCH in accordance with NETZSCH specifications.
- Any warranty is void if other parts or materials are used!
1.7 Specified use, improper application
This machine is solely for the purposes of conveying the conveyor media, referred to
the data sheet (→ Chapter 15) and under the operating conditions which are also
described there.
Any usage which goes above and beyond this must be agreed with NETZSCH in all
cases and shall only be permitted following written approval from NETZSCH.
The operational safety of the supplier machine is only guaranteed if it is used for its
specified purpose.
This machine has been designed on the basis of defined operating conditions. The
limit values for the operating conditions are specified on the data sheet (→ Chapter 15)
and must be observed in all cases.
text no.
R 01004-2/3
issued: 03.05.2016 Revision: 3
copy to:
IPP - EN - EN_01004_20160503/4 - D8411276 - 4300003998 - 000100 - NPS - 00229929 N 2018-02-21 19:03:25
To Next Page
Loading...