Chapter 4 – Using Your MindWave
3. Allow the ear hoop to wrap around the back of your left ear and clip the earclip onto your
earlobe.
4. Make sure the two metal contacts on the inside of both sides of the earclip make skin-contact
with your earlobe or ear. Move any hair or obstructions out of the way. Readjust the earclip as
necessary to make proper contact with your ear.
5. Adjust the Forehead Sensor Arm of the headset so that the Forehead Sensor makes contact with
your forehead. is sensor must maintain contact in order to properly measure your brainwaves.
e sensor should be comfortable, yet stay in position. Keep hair away from the sensor – the
sensor must be able to directly contact the skin at all times.
6. is is how the MindWave should look when properly worn. During usage, if you are not re-
ceiving a signal, repeat the steps above to make minor adjustments to ensure the sensor and
contacts have proper skin contact.
Fitting the MindWave
September 10, 2010 | © 2009 NeuroSky, Inc. All Rights Reserved.
14
To Next Page
Loading...
