User Manual
-20-
Chapter4. Maintenance
2. Change the battery timely when low power alert sounds.
3. Keep away from corrosive material or any liquid,
4. Do not hang anything on the handle.
5. Keep the emergency key.
6. Keep the surface of the sensor clean and dry.
7. Keep your fingers clean when using this product.
8. In the state of new lock (factory setting), the lock can be unlocked with
any fingerprint.
9. When opening the door, if the lock beeps an alarm and the indicator
light flashes red, it's indicating the lock is in insufficient voltage level.
Please change the batteries.
10. This product can save 99 fingerprints, among which 1 is the Super
Master (Code: 01), and 2 Masters (Code: 02-03), and the other 96 are
member fingerprints (Code: 04-99)
11. Deletion of fingerprint is to delete each fingerprint separately accord-
ing to its code; the fingerprint cannot be deleted unless you know the
code.
12. Do not clean the lock surface with corrosive substance, or else the
protection layer may be damaged and thus influence the gloss of the lock
surface. Therefore please clean the lock surface periodically with furni-
ture polish wax (e.g. Pledge).
13. If the latch bolt fails to draw back and forth freely, or the door cannot
be closed normally due to the distortion of the door, please adjust the
strike plate's position.
14. When the fingerprint and password fails to work, use the mechanical
key to open the door; please keep the mechanical key in a proper place.
15. Customer Service Hotline: 1-866-572-LOCK
(5625)
1. Warranty will become void if the warranty seal on the back of the front
and back panel is broken.
To Previous Page
Loading...