New Image FITT ROW - Assembly: Steps 2 and 3; Installing Runner Rail and Limiters; Attaching the Rear Stability Leg

1. Remove the M4 screw (25) from the upper and lower rail covers (36&37)
2. Slot the upper and lower rail cover (36&37) together around the end of the guide
rail (33). Fix in place using the M4 screw (25) and Multi wrench (B).
3. Fix rear stability leg (38) to the bottom of the guide rail (33) with washers (3), spring
washers (11) and M8 Screw (24) using the Allen Key (A).
Step 3
1. Remove 2x M5 screws (31) from the runner rail (33) using Multi wrench (B).
2. Slide the seat (40) on to the runner rail (33) and move to the centre of the rail.
3. Replace the 2 x M5 screws (31) using the Multi wrench (B).
4. Fix the limiters (34) to the runner rail (33) with cross head screws (35) using the
Multi wrench (B).
Step 2
24
11
3
33
36
37
38
25
31
32
40
33
35
34
34
(B) Multi Wrench 1pc
(35) M6x16mm 2pcs
(34) 2pcs
(31) M5x10mm 2pcs
(11) M8 Spring washer 4pc
(24) 4pc
(A) #5 1pc
(B) Multi Wrench 1pc
(25) 1pc
(3) M8 Flat washer 4pc
M8 screw
M4 screw