Newco Bistro Touch - Software Updates and Error Resolution; Troubleshooting Error Displays; Error Cause and Remedy Guide

22

Load Software Update
TROUBLESHOOTING SCREENS
These e
r
r
or screens will display a service phone number to call if entered in “Setup” Menu (Page 15)
*Usuall
y
repairing a bad connection or replacing the indicated moto
r
will remed
y
the problem.
minutes
Hysteresis cycle
Display Reads Possible Cause(s) Remedies Notes

Fill Timeout Error

Water shut off to Machine Check Water Supply Shutoff
Initial fill time longer than 8

Supply Line Blocked or too small Repair or Replace as needed Fill time Longer than 1 Minute


Water Filter Restricted Replace-Service Required
Water Probe has a 30 second

Inlet Solenoid valve Faulty Replace-Service Required

Control Board Failure Replace-Service Required
Thermistor Error Thermistor not plugged in Make sure plug in housing is latched Open or Shorted Thermistor

Faulty Thermistor Replacement

Control Board Failure Replace-Service Required
Heater Error Faulty Thermistor Replacement 4 Minute Continuous Heater Run

Faulty Heater Element Replace-Service Required

Control Board Failure Replace-Service Required
MotorErrors*
Wiring Disconnected- Pumps Check Pump Motor Wires, Harness




Future updates to the Touch Screen Software will be delivered
via e-mail. Instructions for updatin
g
the firmware from a Smart
Phone or Tablet will be included in the e-mail.
