CAFÉ ESPRESSO 2.0 PN 153335 20230322
Technical Service: 1-800-556-3926
8
INSTALLATION INSTRUCTIONS
FILL TANK
The side tank must be filled with water before
plugging in the machine.
If using the water tank, fill to Max Fill line.
If using direct plumbing, fill tank with at least 16
ounces of water. Water may be discarded after
installing the machine.
ADJUST DISPENSE COLUMN
The machine is shipped with the Dispense Column in
the fully raised position. Grab the sides of the column
to adjust it to the desired height.
CONNECT MILK HOSE
If you are using the Milk Thermos, then use the milk
hose with fittings on both ends (PN 152818). If you are
using any other milk container, or when running a
deep clean of the milk frother, then use the milk hose
with one fitting and one slotted end (PN 152848).
The straight fitting connects to the right side of the
dispense column, and the other end should connect
to the drip tray when not in use.
ADD BEANS
Pour beans into bean hopper on top of machine.
Note: There is a dial that can be used to adjust the
size of the grind. Super fine grinds are more likely to
clog the machine. See page 13 for more information.
Note: Do not use frozen or specialty beans (i.e.,
cocoa or sugar coated) in this machine.
CONNECT DIRECT PLUMBING (IF APPLICABLE)
Flush water line before attaching to machine or filter.
Screw on water line adaptor provided in Starter Kit,
then attach water line.
Note: If you have purchased a water line filter, read
all instructions provided and flush the filter before
attaching it to the water line adaptor.
Once machine is on, set water source in
programming, see Water Supply on page 20.
CONNECT POWER
Plug in power cord to machine then plug power cord
into wall outlet.
To Next Page
Loading...
