SPECIFICATIONS
2-2 SERHT50NA A0808
SPECIFICATIONS
SYMBOLS/LABELING TABLE
Controls/Alarms/Monitors Range/Selection
1. MODE (Pressure or A/CMV
Volume Control) SIMV
SPONT
2. Volume Control (Tidal Volume) 100 to 2,200 mL, ATPS, ± 10%
3. Pressure Control PEEP + 5 to 60 cmH
2
O / mbar
(Target Pressure)
4.
V
•
(Flow) 6 to 100 L/min
5. t
I
(Inspiratory Time) 0.1 to 3.0 sec
6. ƒ (Frequency) 1 to 99 b/min
7. Ptrig (Sensitivity) –9.9 to 0 cmH
2
O / mbar, pressure triggering
(Patient Effort Indicator LED blinks once each time the airway
pressure reaches the Ptrig setting.)
8. PEEP/CPAP 0 to 30 cmH
2
O / mbar
9. P support (Pressure Support) 0 to 60 cmH
2
O / mbar above baseline pressure,
limited to PEEP + Psupport <
60 cmH
2
O / mbar
10. I:E Ratio 1:99 to 3:1
11. Maximum Limited Airway 100 cmH
2
O (98 mbar)
Pressure (Safety Valve)
12.
Manual Inflation 3 sec maximum
(While b
utton is pushed, the ventilator closes the exhalation
valve and delivers a operator controlled breath to the patient.)
13. Humidifier (Optional) 19ºC to 39ºC
14. Airway Pressure Meter –10 to 100 cmH
2
O / –10 to 98 mbar
15. Alarm Silence/Reset Button Pressing button silences an audib
le alarm violation for 60
& Indicator seconds and resets a latched alarm indicator. LED lights to
indicate that Silence is activ
e
16. ALARMS Indicators Indicators for violated alarms blink red. When the alar
m is no
longer violated, the indicator latches (stays lit). Cancel a latched
indicator by pressing the Silence/Reset button.
17. Int. Battery Button & Indicator Pressing button displays the internal battery charge level in the
airw
ay pressure meter (Paw) window when operating on the
internal battery system for accurate reading. LED lights to
indicate internal battery system operation and alarms.
To Next Page
Loading...
