14
4.4 Connect to the Battery
The motor is adaptable with 36V (three 12V batteries connected in
series) deep cycle marine battery package, 36V LFP lithium battery
(including three 12V LFP lithium batteries connected in series) and 36V
lithium cobalt oxide battery package. Please follow the steps below to
complete the battery connection.
1. Find the battery cables from the motor; there should be a red and
a black cable.
2. Connect the red cable to the positive battery terminal and the
black cable to the negative battery terminal.
3. Make sure the battery cables are connected to the correct terminal.
The motor will not operate if battery cables are installed incorrectly.
4. Tighten the connection of the battery cables to the battery
terminals. Make sure the connection is solid and secure.
Be sure all switches are in the OFF position
before connecting to battery or batteries. Electrical arcing near the
battery could cause an explosion. The battery produces hydrogen
and oxygen gases while charging. This potentially explosive
mixture escapes through the ll vent cell caps and may form an
explosive atmosphere around the battery for several hours after
it has been charged. Electrical arcing or ames can ignite the gas
and cause an explosion, which may shatter the battery and could
cause blindness or other serious injury.
Deppy cycle Batteries contain sulfuric acid,
which can cause severe burns. Avoid contact with skin, eyes and
clothing.
To Next Page
Loading...
Need help?
General
