29
7.5 Replacing the Propeller
You can replace the propeller if it is damaged. To do this, follow the
steps below with the assembly diagram:
1. Attach the washer.
2. Insert the drive pin into the hole on the motor output shaft.
3. Rotate the propeller until the drive pin is seated correctly in the
corresponding channel on the backside of the propeller.
4. Place the washer on the motor shaft after the propeller.
5. Tighten the hex locknut with 17mm socket wrench.
Washer
Drive Pin Propeller
Washer
M12 Nut
To Next Page
Loading...