18
5.3 Error Status Display
The icons indicated on the LCD screen above show three possible
error statuses of the motor. When a fault occurs, there will be a
corresponding code on screen to help diagnose the problem. See
section 5.4 Error Codes and Solutions.
Motor Overvoltage: If the input voltage is too high, this icon will light
up and keep ashing. Please make sure the input voltage to the motor
is correct (24V or 25.9V). Ensure the correct battery option is selected
(D or Li).
Motor overheated: If the motor driver PCB is over heated, this icon will
light up.
Motor stalled: If the motor is stalled, this icon will light up. Please
disconnect from the battery and check to see if the propeller has been
tangled in weeds or shing line- these can also get wrapped behind
the propeller. Clean the propeller and resume running.
Battery Voltage
Too High
Battery Voltage
Too Low
Driver PCB
Over heated
Kill Switch
is Off
Motor
Stalled
Motor Has Error
To Next Page
Loading...
Need help?
General
