GEO M12 HARDWARE SETUP PROCEDURE Page 29/90
6.2.4 GEO M12-I and MSUB18-I rigging systems
For permanent installations where systems won’t have to be frequently assembled and disassembled
- GEO M12 AutoRig
TM
is replaced by an axis with break nuts
- GEO M12 rear pin is replaced by a shoulder screw with a break nut
- MUB18 semi auto-lock system is replaced with pins and safety clips
Please note that these are shipped together with GEO M12-I and MSUB18-I
6.2.5 Accessories
GEO M12 & MSUB18 accessories are:
To Next Page
Loading...
