PRESET
P10 Page 7 / 18
PRESET
Please consult nexo-sa.com for NEXO TD Controllers firmware information.
For the P10, the following setups are available:
→ MAIN is the recommended setup for most FOH application.
→ MONITOR is recommended for monitor applications. Warning: this setup is a low latency setup and therefore its phase is not
compatible with other NEXO cabinets, including subs.
Preset
• P10 MON PA 100100, with high-pass at 63, 85 or 120 Hz.
• P10 MON PA 11060, with high-pass at 63, 85 or 120 Hz.
• P10 MAIN PA 100100, with high-pass at 63, 85 or 120 Hz.
• P10 MAIN PA 11060, with high-pass at 63, 85 or 120 Hz.
P10
To Next Page
Loading...
