VIDEO MODE (CONTD.)
Continued from previous page.
9. Speed Stamp
Turn On / Off the Speed Stamp shown on recorded files.
Options: On and Off
Default Setting: On
10. GPS Location Stamp
Turn On / Off both the GPS co-ordinates and speed stamp that are shown on recorded files.
When a recording is viewed using the supplied NEXTBASE Replay playbck software both the
GPS co-ordinates and speed information remains available.
Options: On and Off
Default Setting: On
11. Nextbase Stamp
Turn On / Off the NEXTBASE Stamp shown in the top left corner of recorded files.
Options: On and Off
Default Setting: On
12. G Sensor
Turn Off or adjust the sensitivity of the built in G Sensor. The G Sensor detects forces which
will automatically protect the current recording in event of a collision.
Note:
- This does not affect Parking mode sensitivity.
Options: High, Medium, Low and Off
Default Setting: Medium
Note:
- Within the Setup Menu which is accessed by pressing the MENU button twice, there is
a ‘Default Settings’ option to allow you to reset the iN-CAR CAM to the factory defaults,
if required.
Video Menu
Resolution
Exposure
Audio Recording
Video Length
Back
MENU
Enter
OK
Video Menu
Speed Stamp
GPS Location Stamp
Nextbase Stamp
G Sensor
21
To Next Page
Loading...
Need help?
General
