IN VEHICLE INSTALLATION (CONTD.)
Step 5: How to remove the Dash Cam
Typically there is no need to remove the Dash Cam from the vehicle, as recordings can be viewed
via the CAM Viewer App or by removing the SD card from the Dash Cam using it directly with your
PC.
However, should you wish to remove the Dash Cam then remove the straps and move the Dash
Cam upwards to release it from the suckers. The suckers can then be easily removed from the
rear-view mirror by using the lifting tab to break the suction.
Note:
- Do NOT wire the Dash Cam directly to a 12V supply by cutting the cigarette plug off the end of
the cable, or damage will result.
- A Nextbase hardwire kit is available from your retailer. This connects directly to the vehicle
fusebox and hence leaves your cigarette socket available for Phone / Sat Nav charging.
The Nextbase hardwire kit includes the necessary 12-24VDC to 5Vdc convertor and battery
protection circuitry.
- If a USB cable is used to power the Dash Cam and the Dash Cam starts up straight in to the
PC Connection screen showing Mass Storage, Power On and Update, then the Dash Cam has
detected that it has been connected to a computer and not just a simple USB power supply.
A simple “Power ONLY” USB cable is required in this situation. Contact Nextbase Product Support
for further assistance.
15
To Next Page
Loading...
Need help?
General
