•
Picture No.: 1 photo, 2 photo, 3 photo
Select the number of photos to be taken in succession when the camera is triggered in the Photo
mode. Please also observe the parameter Interval!
16
• Video length: 10 sec(onds), optional 1 - 60 seconds and 3, 5 and 10 minutes
Specify the duration of a video recording when the camera is triggered automatically. The recording
period for videos is not limited in the Test mode.
• Interval: 30 sec(onds), optional from 5 seconds to 60 minutes
Select the shortest period for the camera to wait before it reacts to the successive triggering of the
main sensor after an animal has rst been detected. The camera does not record any images or videos
during the selected interval. This prevents the memory card from being lled with unnecessary shots.
• Time stamp: On/O (only available for photos, not for videos)
Select "ON" to print the date, time, temperature and moon phase on each photo. Otherwise select
"O".
• Time switch: O/On
Set timer to "On" if camera should only be active within a certain time. Once "On" has been conrmed
with the OK button, the start and end time can be set.
If the start time is, for instance set to 18:35 hrs and the end time to 8:25 hrs, the camera will be
operational from 6:35 pm of the current day until 8:25 am of the following day. The camera will not be
triggered and will not take any photos or videos outside of this period.
• Password Set: O/On
After selecting "On" enter a four digit password to protect your camera against unauthorised access.
This password must be entered each time the camera is switched on in the Test mode before the
camera can be used.
Note:
•
1M, 3M, 5M can choose 1 photo, 2 photos, 3 photos;
8M can choose 1photo, 2 photos, but 3 photos not available;
12M, 16M can choose 1photo, but 2 photos, 3 photos not available.
To Next Page
Loading...
