Nextech QC8061 - Night Recording; Setting up the Live Mode; Aligning the Camera

18
• Default set: No/Yes
Press “Yes” to reset the camera settings to the default values and conrm the selection by pressing the
OK button.
• Auto power o: 3min/5min/10min/o
With this function you can determine whether the camera should be automatically switched
o when not used for some time in the Test mode. Set the time after which the camera should be
switched o in the Test mode or deactivate automatic switch o by selecting “ OFF”.
The camera can be switched on again by pressing any operating button.
• Volume Rec: O/On
• Beep Sound: O/On
• Volume play: Low/Normal/High
Select with which volume audio recordings are to be played back.
• System: There are two available options:
FW Update: If the memory card contains new rmware this can be installed by conrming the option
by pressing the OK button.
During the update the respective status is shown on the display.
FW Version: Shows the rmware version installed on the camera.
In replay mode the option Delete is available in the menu.
• Delete: Select the "Delete" option to remove individual or all photos from the memory
card thus making storage room for new photos.
Single
: Using this option you can delete individual photos. After selection the option by
pressing the OK button, the photo to be deleted is shown. You can toggle between photos
using the
buttons and . As soon as the deletion of a photo has been conrmed by
pressing "Yes", the
photo is deleted and the next photo is displayed. To end the deletion
process, select "No" and conrm by pressing OK
.
 
All: Select option "All" to delete all photos on your memory card. To conrm deletion of all
your photos, select "Yes" and press the OK button. Select "No" to interrupt the deletion
operation.