10
USING YOUR CAMERA
CAMERA SETTING INFORMATION
Mode: Selects the format your camera will record in.
Photo: For photos only.
Video: For videos only.
Photo+Video: A photo followed by a video clip will be captured for each PIR trigger
event.
Interval: Defaulted 30seconds, optional from seconds to 60minutes
Select the short setup period for the camera to wait before it reacts to the
successive triggering of the main sensor after an animal has first been detected.
The camera does not record any images or videos during the selected interval. This
prevents the memory card from being filled with unnecessary shots.
Time lapse: Off/On
When “on” has been selected, the camera would automatically take photos/ videos
in the selected time interval, irrespective of whether or not the PIR sensor has
detected a motion or not. This is useful for observing cold blooded animals e.g.
snakes or plants opening up, etc.
As soon as the “On” setting has been confirmed by pressing the OK button, you can
enter the interval time after which photos/ videos are to be taken.
Periodic Interval Set: OFF. This function is to set up the PIR interval time and not
recommended to use. When Periodic Interval Set function open, the PIR function
would be disabled.
PIR Sensitivity: High/ Medium/ Low
High: Recommended when air temperature is above 70° or when maximum range
is desired.
Medium: Recommended when air temperature is 45 to 70° or when range is up to
70.
Low: Recommended when air temperature is below 45° or when range is up to 40.
NOTE: The interval time is short, the camera shooting frequency would be high,
and there would be high consumption of batteries. It would affect the usage days
of the batteries. It is just on the opposite ,the interval time is long, would be a lower
consumption of batteries to guarantee a long time usage.
NOTE: In this mode, the PIR function would stop working, and the camera would
take photos/ videos in the setting interval time.
To Next Page
Loading...
