Nextech QC8067 - Advanced Camera Settings; Time Stamp and Temperature Settings; Security and Power Settings; Display and Language Settings

13
NOTE: If you forgot your password, please unlock the camera with password “OPEN”
camera name, then enter the new name using the arrow buttons and keyboard.
Press the OK button to select a letter. Press MENU to save the name to memory.
Time Stamp: On/ Off
Select “ON” to print the data, time, temperature and battery percentage on each
photo or video. Otherwise select “OFF”.
Temperature: Fahrenheit/ Celsius
The temperature units can be displayed in Image Data Strip in either Fahrenheit or
Celsius.
Password Setting: Off/On
After selecting “On” enter a four digit password to protect your camera against
unauthorised access. This password must be entered each time the camera is
switched on in the SETUP mode before the camera can be used.
Beep Sound: On/Off
Auto Power Off: 3 min/5 min/10 min/Off
If there is no operation more than the selected time, then the camera will turn off
automatically in SETUP mode.
Backlight Time: 1 Minute, 3Minutes, 5Minutes, Off
The LCD monitor would automatically turn off after the setting time.
Language: Select the desired language in the meu list.
Format: No/ Yes
Deletes all files stored on a card to prepare it for reuse. Always format a card
that has been previously used in other devices. Caution! Make sure you have
downloaded and backed up any files you want to preserve first!
Press OK to execute, press MENU (or select NO then press OK) to exit without
formatting.
TF Detection: No/ Yes
Select “Yes” and press OK to test your TF card speed. If it shows “Test passed”
meant your TF card is high speed and qualified to use by the camera. If “TF Speed
too low” show, you need change another high TF card at least Class6 or higher.
Reset to Factory: No/ Yes
Select “Yes” and press OK to restore all parameters to the original factory default
settings. IF the camera is behaving oddly and you think you may have changed the
setting for something accidentally (but aren’t sure which one), this will reset all
parameters to their most commonly used or “generic” settings.
System: FW Update/FW Version
FW Update: No/Yes. Allows users to update the FW when the updated FW in the TF
card.
FW Version: Displays firmware version.