A.14
MASTER
TRACE
Appendix A
Display Message
Details - Setpoints
MESSAGE NO: S3-22b APPLIES TO: Address Enabled Control
Module
DEFAULT VALUE: None VALUE RANGE: Module Range
DISPLAY MODE: Advanced RESTRICTIONS: MR100 Interface Module
The message “CHECKING MODULE NUMBER: n” is displayed while the
system looks for a module that already has this number. If it finds a module with
this number, the message “MODULE # 1 ALREADY EXISTS” is displayed.
Press [MSSG ò] to continue. A different Module Number must be selected.
If the Checking Module Number function is successful, message number S3-19c is
displayed.
PRESS MSSG DOWN
TO CONTINUE
MODULE #1 &
ALREADY EXISTS
CHECKING MODULE
NUMBER: 1 &
ô
ô
MESSAGE NO: S3-22c APPLIES TO: Address Enabled Control
Module
DEFAULT VALUE: None VALUE RANGE: None
DISPLAY MODE: Advanced RESTRICTIONS: MR100 Interface Module
This message provides a last chance to confirm the Module Number Change.
Press [MSSG ò] to proceed.
This message indicates that the SET MODULE Number function was successful.
Press [MSSG ò] to continue.
This message asks you to disable Address Mode and check that the Control
Module Address LED is off. Press [MSSG ò] to continue. Refer to Chapter 5.1.2.
ABOUT TO SET
NEW NUMBER
CONT - MSSG DOWN
ABORT - RESET
ô
ô
MODULE NUMBER
ASSIGNED
ô
PRESS MSSG DOWN
TO CONTINUE
ô
SET ADDR DISABLE
ADDRESS LED OFF
ô
PRESS MSSG DOWN
TO CONTINUE
To Next Page
Loading...