MASTER
TRACE
A.15
Appendix A
Display Message
Details - Setpoints
PRESS MSSG DOWN
TO CONTINUE
NO RESPONSE
ADDRESS LED OFF?
CONT - MSSG DOWN
ABORT - RESET
SET ADDR ENABLE
ADDRESS LED ON
ARE YOU SURE?
no ?
READ MODULE
NUMBER? no ?
yes
ò
yes
ò
ô
MESSAGE NO: S3-23 APPLIES TO: Address Enabled Control
Module
DEFAULT VALUE: n o VALUE RANGE: yes, no
DISPLAY MODE: Advanced RESTRICTIONS: MR100 Interface Module
This function reads the Module Number of a Control Module with Address
Enabled. The Module Number of each Control Module on a data highway or
connected to a MR100 Interface Module is unique. Select “yes” to proceed. Select
“yes” again to confirm.
This message asks you to confirm that the Control Module Address is “enabled”.
The Control Module Address light must be on. Press [MSSG ò] to proceed. Refer
to Chapter 5.1.2.
ô
MESSAGE NO: S3-23a APPLIES TO: Address Enabled Control
Module
DEFAULT VALUE: None VALUE RANGE: None
DISPLAY MODE: Advanced RESTRICTIONS: MR100 Interface Module
If you receive the message “NO RESPONSE …”, check that the Control Module
Address is “enabled” or refer to Appendix C: Summary of Alarms and their
Causes, NO RESPONSE ALARM. Press [MSSG ò] to proceed.
MESSAGE NO: S3-23b APPLIES TO: Address Enabled Control
Module
DEFAULT VALUE: None VALUE RANGE: Module Range
DISPLAY MODE: Advanced RESTRICTIONS: MR100 Interface Module
This message displays the Module Number and indicates that the READ MOD-
ULE function was successful. Press [MSSG ò] to proceed.
This message asks you to disable Address Mode and check that the Control
Module Address LED is off. Press [MSSG ò] to continue. Refer to Chapter 5.1.2.
MODULE NUMBER
1 &
ô
PRESS MSSG DOWN
TO CONTINUE
SET ADDR DISABLE
ADDRESS LED OFF
ô
PRESS MSSG DOWN
TO CONTINUE
[
MSSGò
]
To Next Page
Loading...