Nextron MASTERTRACE - Page 76

A.16
MASTER TRACE
Appendix A Display Message
Details - Setpoints
MR100
CLEARED
yes [STORE]
ARE YOU SURE?
no ?
RESET MR100?
no ?
yes [STORE]
MESSAGE NO: S3-24 APPLIES TO: MR100 Interface Module
DEFAULT VALUE: n o VALUE RANGE: yes, no
DISPLAY MODE: Advanced RESTRICTIONS: MR100 Interface Module
This function resets all values of the MR100 Interface Module to the default
values. Select “yes” to proceed. Select “yes” again to confirm.
This message confirms that the MR100 Interface Module was reset.
MESSAGE NO: S3-25 APPLIES TO: Interface Module
DEFAULT VALUE: N/A VALUE RANGE: N/A
DISPLAY MODE: Advanced RESTRICTIONS: None
This message displays the firmware version number.
FIRMWARE VERSION
D1-02-01
MESSAGE NO: S3-26 APPLIES TO: Interface Module
DEFAULT VALUE: N/A VALUE RANGE: N/A
DISPLAY MODE: Advanced RESTRICTIONS: None
This message displays the operation manual version or reorder number.
MESSAGE NO: S3-27 APPLIES TO: Interface Module
DEFAULT VALUE: N/A VALUE RANGE: N/A
DISPLAY MODE: Advanced RESTRICTIONS: None
This message displays the factory telephone number.
MANUAL VERSION:
1501-0006_1
FOR ASSISTANCE:
(403)735-9555