NF WF1943B - Page 64

4.2 Sweep
4-16 WF1943B
(2) Set the sweep TYPE to FREQ
① Use the
and keys to produce the following display (TYPE flashes).
ＦＲＥＱ ＰＨＡＳＥ
Ｆ－ＳＷＰ：ＴＹＰＥ ＳＯＵＲＣＥ ＭＯＤＥ
4
② Press
ENTER
key, then use the and keys to produce the following display
(FREQ flashes).
ＦＲＥＱ ＰＨＡＳＥ
Ｆ－ＳＷＰ：ＴＹＰＥ ＳＯＵＲＣＥ ＭＯＤＥ
4
③ This sets the sweep type for frequency. Press the
EXIT
key once to release the type setting mode.
(3) Select sweep FUNCTION
① Use the
and keys to produce the following display (FUNCTION flashes).
ＬＩＮ
Ｆ－ＳＷＰ：
3
ＦＵＮＣＴＩＯＮ ＳＴＡＲＴ ＳＴＯＰ
4
② Press the
ENTER
key.
③ Press the
key, then select with the
MODIFY
dial.
④ After selecting, press the
EXIT
key once to release the function select mode.