2 | ni.com | NI 9211 Calibration Procedure
Documentation
Consult the following documents for information about the NI 9211, NI-DAQmx, and your
application software. All documents are available on ni.com and help files install with the
software.
Test Equipment
Table 1 lists the equipment recommended for the performance verification and adjustment
procedures. If the recommended equipment is not available, select a substitute using the
requirements listed in Table 1.
NI cDAQ-9174/9178 Quick Start
NI-DAQmx installation and hardware setup
NI 9211 Operating Instructions and Specifications
NI 9211 specific information, specifications, and calibration interval
NI-DAQmx Readme
Operating system and application software support in NI-DAQmx
LabVIEW Help
LabVIEW programming concepts and reference information about NI-DAQmx VIs and
functions
NI-DAQmx C Reference Help
Reference information for NI-DAQmx C functions and NI-DAQmx C properties
NI-DAQmx .NET Help Support for Visual Studio
Reference information for NI-DAQmx .NET methods and NI-DAQmx .NET properties, key
concepts, and a C enum to .NET enum mapping table
Table 1. Recommended Equipment
Equipment Recommended Model Requirements
Calibrator Fluke 5520A locked in
the 3.3 V range
A high-precision voltage source with ≤7 μV of
uncertainty at 75 mV and ≤2 μV of uncertainty
at 0 V and an output impedance <5 Ω.
Chassis NI cDAQ-9178 —
Connection
Accessory
NI 9932 —
To Next Page
Loading...
