NI cRIO-9056 - User Manual

GETTING STARTED GUIDE
cRIO-905x
Embedded CompactRIO Controller with Real-Time Processor and
Reconfigurable FPGA
This document describes how to begin using the cRIO-905x.
In this document, the cRIO-9053, cRIO-9054, cRIO-9055, cRIO-9056, cRIO-9057, and
cRIO-9058 are referred to collectively as cRIO-905x.
Note Refer to the device Safety, Environmental, and Regulatory Information
document, shipped with your cRIO-905x controller and available on ni.com/
manuals, for important safety and environmental specifications necessary when
setting up your device.
Unpacking the Kit
Notice To prevent electrostatic discharge (ESD) from damaging the device, ground
yourself using a grounding strap or by holding a grounded object, such as your
computer chassis.
1. Touch the antistatic package to a metal part of the computer chassis.
2. Remove the device from the package and inspect the device for loose components or any
other sign of damage.
Notice Never touch the exposed pins of connectors.
Note Do not install a device if it appears damaged in any way.
3. Unpack any other items and documentation from the kit.

Summary

Unpacking the Kit

What You Need to Get Started

Installing Software on the Host Computer

Install Software

Details the application software and device drivers to install on the host computer.

Software Compatibility Resources

Installing the C Series Modules

Connecting the cRIO-905 x

Connecting the Controller to Ground

Connecting the Controller to Power

Connecting the Controller to the Host Computer

Discovering the Controller in MAX

Setting a System Password

Installing Software on the Controller

Testing Your Controller in MAX

Changing Module Programming Modes in MAX

Troubleshooting the Controller

Network Communication Issues

Steps to resolve issues when the cRIO-905x is not communicating over the network.

Verify System IP Configuration

Using the cRIO-905 x in LabVIEW

LabVIEW Project Setup

Guide to creating a LabVIEW project for cRIO-905x in Real-Time modes.

LabVIEW FPGA Project Setup

Adding the cRIO-905 x to a LabVIEW Project

Deploying Your C Series Module in a Programming Mode in LabVIEW

Adding the cRIO-905 x to a LabVIEW FPGA Project

Deploying Your C Series Module in a Programming Mode in LabVIEW FPGA

NI cRIO-9056 Specifications

General

Nonvolatile Storage	4 GB
Operating System	NI Linux Real-Time
Ethernet Ports	2
USB Ports	2
Serial Ports	1
Power Supply	9 to 30 VDC
Operating Temperature	-40 to 70 °C
Chassis Slots	8